No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Scott Venman
Comentado en los Estados Unidos el 4 de febrero de 2025
Works great and the included kit to remove the old cylinder was helpful. I ended up cutting the old cylinder off with a sawzall to use an impact driver to remove the old cylinder from the chair frame, but it would have been difficult to remove otherwise.
Alan
Comentado en los Estados Unidos el 12 de abril de 2025
Fits my Steelcase Drive chair well, functions smoothly as expected. The "removal tool" didn't help me but I got the old cylinder out with a very long pipe wrench and someone to hold the base while I yarded on it.
GTK
Comentado en los Estados Unidos el 12 de noviembre de 2024
The gas cylinder worked great. It was longer than the original and had a longer travel so it actually improved the functionality of the chair since it now lifts higher (hate chairs that are too low). Pressure is really strong. The extraction tool did not work as expected. I was never able to get the cylinder loose with the extraction rings and actually started to bend the extraction screws. Finally got the old cylinder off by laying the chair on it's side to apply enough leverage with a pipe wrench, but I bought this for the pressure cylinder, not the extraction tool so it's all good.
Steven S. Wolf
Comentado en los Estados Unidos el 30 de septiembre de 2024
Bought a chair that had a tiny cylinder - way too limited - was able to replace it with this in about 10m. Had to watch a video on how to replace the cylinder - but knowing what to hit hard and with what helps a ton. The included mechanism for removing from the chair bottom worked well for me - and from the base you just whack it out of there with a rubber mallet and all is well.Do wish the instructions they included were about 3x larger -- stupid hard to read and not very helpful really -- but watching a youtube video corrected that.
NS
Comentado en los Estados Unidos el 20 de septiembre de 2024
I have only had this for a week so can't comment on longevity, but the cylinder has been great so far.Due to a filing cabinet next to my standing desk, I could not lower the desk far enough to be comfortable using it while sitting in my office chair. If I can;t lower the desk, then I will have to raise my butt. The piston that came with the office chair did not go up high enough so I searched for a replacement that was like Goldilocks's porridge - not too low, not too high. The low is a little bit higher than the original which allows me to still have my feet flat on the ground in that position. The final spot is about 75% raised which works perfectly for my setup and I can put my feet on the cross support of my desk. Eventually I may get one of the foot rest rings to install on the chair but for now I don't think I will need it.The cylinder comes with grippy gloves, which keep your hands clean of lube and allow you a good hold when trying to pull out the original cylinder. They weren't enough for my job as the original was held in place very well. I picked up a channel lock wrench at HD and that gave me the grip and leverage to remove the cylinder. The new one slipped right in. Easy install of the new.I'm not really sure what the rings are for that came with the set so I didn't install them. Maybe to keep the cylinder from pushing too far into the seat bottom? No idea.Overall, 10/10. Would buy again.
Productos recomendados
Mex $9,734.06
Mex $ 1,881 .00 Mex $1,881.00