GoingElectric
Comentado en los Estados Unidos el 14 de febrero de 2025
Took a bit of measuring and trial and error. But this worked out to be a great replacement for a misplaced Thule threaded hitch pin! And reasonable cost to boot!
Dylan Jenkinson
Comentado en Canadá el 6 de agosto de 2024
Was looking for a way to not spend close to $100 for a pin to secure my Thule bike rack, and honestly this is better than I expected. Affordable, but also solid and has worked really well. I'm very happy I purchased it.
Bajajim
Comentado en Canadá el 31 de agosto de 2024
arrived quickly and well made
DeniCH
Comentado en México el 24 de julio de 2024
Precio a una fracción del original para mi rack Thule, quedó a la perfección
David Mathews
Comentado en los Estados Unidos el 6 de mayo de 2024
Got a steal on a Thule bike rack at a garage sale, but it was missing the hitch pin. I though a standard pin would fit, but no. This pin is threaded to use with the Thule design, and the lock secures the rack and the bikes attached to it. The 90-degree key angle is perfect (other locking pins make you squeeze the key in from the end, which is a tight fit on my Suburban). Quality is good, and everything works smoothly out of the box.
Sergio
Comentado en México el 4 de septiembre de 2024
Sigue haciendo su funcion pero definitivamente el material deja mucho que desear, aun lo utilizo pero mi rack de bicis se mueve mucho porque ya no funciona la rosca del pasador, pero aun mantiene este en su lugar entonces si funciona pero no al 100%
Andrew
Comentado en los Estados Unidos el 24 de abril de 2024
The Kuat bike racks for 1.25" receivers are a bit strange in that the hitch pin hole is placed in between where a 1.25" or 2" hole would normally be so that it can be used with either sized receiver. However, that means the holes don't line up and a standard 1/2" hitch pin won't fit! You have to use their included 3/8" hitch pin, but it's really long so it can slide from side to side, the safety clip only clips on the end and not through a hole, and you can't use a standard 1/2" locking hitch pin.Luckily this MaxxHaul threaded hitch locking pin is thin enough to fit through the misaligned holes, and is also cheaper than the Kuat locking pin. You can just ignore the threaded part, or I put an M12 nylon lock nut on to stop the pin from sliding side to side, as shown in the photo. The other side is held by the safety clip.
Daniel Ramos
Comentado en México el 24 de mayo de 2023
Cumple con la función para la cuál la compré
Nelson Rod
Comentado en México el 18 de mayo de 2023
Funciona con el portabicicletas thule Classic t2
ROBERTO W.
Comentado en México el 14 de diciembre de 2023
Lo use como candado de cofre de cxamioneta
Tam
Comentado en México el 26 de octubre de 2023
Buen producto, práctico y resistente.