Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Antena LoRa de 915 MHz para interior 3dBi ganancia Omni SMA macho + cable IPEX, 2 unidades

Envío gratis en pedidos superiores a Mex $600.00

Mex $561.89

Mex $ 258 .00 Mex $258.00

En stock

1.Tamaño:Antenna&ipex-cable


Acerca de este artículo

  • Frecuencia y ganancia: 900 MHz - 930 MHz (915 MHz)
  • Impedancia y SWR: 50 Ω/≤1.8 (SWR aumenta con una orientación de antena de 90 grados)
  • Cable de extensión: cable conector hembra U.FL a SMA. (5.9 pulgadas)
  • Aplicación: diseñado para aplicaciones LoRa IoT, como ESP32 OLED LoRa Board
  • Lista de embalaje: 2 x Antenas de 915 MHz; 2 x Cable de extensión IPEX de 5.9 pulgadas



Descripción del producto


Mary
Comentado en Francia el 17 de marzo de 2025
J'ai bien reçu la voiture
Gary Lofgren
Comentado en los Estados Unidos el 22 de febrero de 2025
It is no secret that the stubby antennas included with Heltec V3's are not particularly effective for getting good range. I was looking for an antenna upgrade for my two units and decided to give this pair a shot based on other positive reviews. I can confirm that these work great and for the price are a good bang for your buck to upgrade the performance of V3's. With the stock stubby antennas, I could receive messages inside my house but attempting to send messages out to the mesh would always fail. I have not had any message failures since swapping over to these antennas.
Jim Wreyford
Comentado en los Estados Unidos el 10 de febrero de 2025
Use this with Meshtastic Heltec v3. Works great. Improved performance.
Scott Thompson
Comentado en los Estados Unidos el 20 de enero de 2025
I’ve been using these 915MHz LoRa antennas for Meshtastic, and they’ve proven to be well-tuned for the 915MHz frequency used in the US. The signal-to-noise ratio (SNR) readings I get with these antennas are nearly identical to those from a known 2.5dBi antenna, so while they are advertised as 3dBi, I suspect the gain is closer to 2.5dBi.The hardware included is of decent quality, and the antennas perform best when used straight rather than bent at a 90-degree angle. For example, I have a PORTDUINO node set to CLIENT_MUTE on my desk in my basement office, and it consistently connects with nodes up to 3 miles away.These antennas are reliable, well-built, and a good choice for anyone working with Meshtastic in the 915MHz range. Despite the questionable gain rating, their performance and build quality make them a worthwhile purchase for DIY LoRa projects.
Jorge Tijerina
Comentado en México el 16 de enero de 2025
Funciona para lo que las compré
IVAN MENDOZA
Comentado en los Estados Unidos el 18 de agosto de 2024
LOOKS SMALL BUT IT OK . HAPPY WITH IT
Nemesio A.
Comentado en México el 19 de marzo de 2024
un carrito de la marca Jada Toys a un excelente precio
D. Paul
Comentado en los Estados Unidos el 11 de diciembre de 2024
These are the best alternative to the basic stubby antenna that comes with most LORA devices. Decent SWR readings negative SNR bd and RSSI dBm but about 50% better than the stubby.
Bredam Asee
Comentado en los Estados Unidos el 23 de noviembre de 2024
I purchased this for a project for a school play prop using 2 RP2040 micro-controllers (Adafruit Feather RP2040 LoRa RFM95) , 1 for the prop and 1 for a remote. The receiving prop is a clock so originally I incorporated the antenna on the back, but I found that I could still easily send signals from the stage to the tech booth of the theater with only the connector cable attached to the clock (not the actual antenna) but with the full cable+antenna connected to the remote control. The distance is maybe 200ft so I'm extremely satisfied with the results.The build quality on these antenna seem excellent. Would purchase again if needed.
REMZİ KEMAL GÜNERİ
Comentado en Turquía el 17 de abril de 2024
Anlatıldığı gibi
Nicolle
Comentado en México el 3 de diciembre de 2023
Está hermoso el carro pero realmente maltrataron mucho la caja y lo compré para un regalo...
Luis
Comentado en España el 18 de noviembre de 2023
Junto al Mitsu de 2 Fast 2 Furious
Héctor
Comentado en México el 24 de agosto de 2022
Me gustó mucho mi inversión, en magníficas condiciones llegó.El precio es acordé .Lo importante que llegó y llegó muy bien
BERNARDO ALEJO VANDEN BOUCH
Comentado en México el 22 de febrero de 2022
EL BLISTER LLEGO ROTO, LA PIEZA BIEN PERO SI PAGO CARO,PUES ESPERO QUE LLEGUE EN EXCELENTE ESTADO, PARA QUE LO TOMEN EN CUENTA EN LAS BODEGAS CON EL PROVEDOR O EN PAQUETERIA, YA ME HANLLEGADO VARIAS PIEZAS MUY MALTRATADAS.
neil
Comentado en el Reino Unido el 21 de octubre de 2022
Great detail from a great company
Cliente de
Comentado en México el 3 de octubre de 2020
Increíble auto a escala. Una perfecta copia del original.
Aldo Perez
Comentado en México el 11 de mayo de 2019
Excelente artículo muchas gracias, cada diseño es muy original y hecho como réplica exacta
Productos recomendados

Mex $148.00

Mex $ 82 .00 Mex $82.00

5.0
Elegir

Mex $151.00

Mex $ 89 .00 Mex $89.00

5.0
Elegir