No hay artículos en el carro
No hay artículos en el carroshonta
Comentado en los Estados Unidos el 9 de marzo de 2025
Perfect fit! Saved me $250. Watched a YouTube video on installation. I had it changed out in a few hours. Works perfectly.
ThePotatoMan
Comentado en los Estados Unidos el 8 de enero de 2025
no issues after a year
non_compos_mentis
Comentado en los Estados Unidos el 2 de septiembre de 2024
Parts don't seem quite as robust as the originals, but we're back in business again, so I'm not complaining too much. Yet.Very pleased it is still possible to replace parts and not just toss an otherwise functional appliance. Fighting the "everything's disposable" mentality one fix at a time.Longevity TBD.
Andrek79
Comentado en los Estados Unidos el 2 de abril de 2023
UPDATE: The wheel is already failing, with a loud squeek when the bearings stop working & the wheel locks up for 5-120 seconds at a time.ORIGINAL: As seen in the images, you will need additional hardware. DO NOT TRY TO REUSE ORIGINAL FASTENERS.Extra Purchase Needed:* 10mm Split Lock Stainless Washer.* Two 10mm 1.5pitch Stainless Jam NutsLuckily I only needed to replace a single roller (blue roller in the images). The original large broken flange nut sheared off the NON-STAINLESS STEEL roller axel. I can't get it off at this point. The other roller broke on the opposite side of the axel (having decreased the diameter of the threaded bolt vs keeping a hex head as the original part.I used two jam nuts with a split lock washer Under both of them.I don't know what metal is used, though I feels VERY cheap & I am not confident it will hold up over time.At least I have a temporary fix. I will I find a better replacement for when this fails.I didn't use any of the other parts in this kit since the rollers are such poor craftsmanship.Hope this review helps others who need all the parts at once.
D. Peay
Comentado en los Estados Unidos el 14 de diciembre de 2020
I am pleased with this product. Everything fit. Very important differences:1) The rollers have reverse threading (left to tighten).2) The nut is 17mm rather than 14mm(photo attached)The reason this was difficult is that I didn't have a 17mm wrench and the nut sits in a very difficult place, behind a panel. I found out the hard way that the threading is reversed on this part. The standard LG part is standard threading, so I struggled while laying in an awkward position.ALL parts fit precisely. Seemed like the quality was good.
Productos recomendados