No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Lionel "Lio" L.
Comentado en los Estados Unidos el 1 de abril de 2025
Needed some extra length of cable to be able to mount the AMS on the wall and this set was just what the doctor ordered. Not much to say other than that since it's just an extension cable for the AMS Lite with no other function than to make a cable longer...
Steve R.
Comentado en los Estados Unidos el 12 de abril de 2025
This cable is very convenient and useful if you keep your AMs in an inconvenient spot from your A1.I've never used the side mount as I printed and started using the top-mount right away, and then found this vertical, rotating mount that clamps to the back base of the machine. Very good in space saving and greatly reduces the amount of shaking/vibration on the A1 during printing.The only problem is that the standard AMS cable doesn't reach the port if you want the numbers facing right-side up, so I ordered a set of 2 of these cables and they work great, as you can see in the pic, the cables are running from the top rear of the 2 AMS's, with plenty of room to the port on the back.So much extra room that I needed to twist-tie the slack while still having room to rotate the tower.I gave this 4 stars only because 1 of the 2 pack I bought didn't fit the plug and needed to order another cable.Upon placing my return order for it, they did not ask for me to return the bad cable after issuing the refund so I can buy the replacement, which I guess is convenient, but I can't do anything with the bad one so I'm probably just going to throw it away.Other than that, my only other nit-picky complaint would be that they make some kind of clip receiver to accept the fastener clip on the end of the original cable to ensure proper security, especially for something that hangs like this.No clip insert, so you just push them together until they feel tight and secure enough with the clip on the original just sitting on a flat surface. Could be worse, I guess, but a small divot for that clip to rest in would be a great improvement.
Productos recomendados