Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

CESS Conector de cable MIDI DIN de 5 pines (paquete de 10)

Envío gratis en pedidos superiores a Mex $600.00

Mex $299.25

Mex $ 134 .00 Mex $134.00

En stock

Acerca de este artículo

  • Nombre del producto: conector de enchufe DIN de 5 pines
  • Tipo de soldadura de conector macho DIN


Conector de enchufe DIN de 5 pines


lucian calugaru
Comentado en los Estados Unidos el 29 de agosto de 2023
I was pleasantly surprised to see they still exist. Do not overheat when soldering your wires to the metal pins, they may displace from the plastic collar
Benjamin Kleber
Comentado en los Estados Unidos el 3 de noviembre de 2023
Got these so I could make some manual controls and one-off interfaces between a motor, a switchbox, and a small computer interface. Had zero difficulties. Soldering into the pins was easy. Slightly annoying soldering onto the shield layer, but that's always the case and not a failing of this part. Full success, very happy.
Kenneth Lee
Comentado en los Estados Unidos el 1 de noviembre de 2021
if your restore CB's and other radios, you have to have the right microphone plugs.
BCengineer
Comentado en los Estados Unidos el 27 de diciembre de 2020
Solder points are small and the casing slides off easily unless you pull the metal tab up a bit. Not great but if you aren't going to using them on the go they should be ok. Permanent to semi-permanent installs would be best.
CRS
Comentado en los Estados Unidos el 25 de marzo de 2019
These are very simple connectors that you disassemble to solder on wires. I've been looking at the midi hammer units that are supposed to be the lowest profile mid cables , but since I need to make custom lengths I decided not to pay the premium just to cut off one end and and resolver. Sure call me cheep. I took one of these apart to try. and cut down the strain relief to just the steel shield end, soldered the wires (bought a hosa 25 foot cable to cut down to custom lengths ) and reconfigured the end after testing the solder connections and added a bit of shrink wrap . See picture for details.I still have to cap the back, So I figure a little elbow grease and time to keep from buying 7 cable's @ about $20 a pop. Over $100 in savings. The midi hammer cable sure are nice though if you have the cash to throw down.
Productos recomendados

Mex $553.33

Mex $ 282 .00 Mex $282.00

4.7
Elegir

Mex $1,677.20

Mex $ 838 .00 Mex $838.00

4.4
Elegir