No hay artículos en el carro
No hay artículos en el carroinjunear
Comentado en los Estados Unidos el 10 de marzo de 2024
WARNING- This is for the older Creality printers that use a 12V hot end! Prior to installing this I bought a 24 volt version erroneously way back in November 2023 which of course was outside the return window when I needed to install it. Needless to say, it did not work s it took nearly an hour to heat the head to slightly above 200 degrees.....My printer is a "cloned" CR10S I bought (here on amazon) nearly 8-10 years ago!Quick and easy to install, essentially "brainless"... I have used other replacement hot ends through the years but for the price of this it simply wasn't worth it to have to splice everything in... Plus you get new fans too. Comes with all the screws, etc. you need to install. Again, MAKE SURE you verify that you need a 12v heater and not the more modern 24 volt. This is 12 volts.
Gustavo L.
Comentado en México el 25 de noviembre de 2024
He logrado con este articulo resolver los problemas de atasco y calentamiento, funciona de maravilla, me agradó y el cambio fue rápido sin problema alguno. Recomendado.
Jim S.
Comentado en los Estados Unidos el 18 de noviembre de 2024
I had a bad fan and just replaced the entire hot end with this and it was a simple remove old and attach new plug it in and works great. Like less than 10 minutes to exchange.
Lance Ginger
Comentado en los Estados Unidos el 21 de agosto de 2022
I ordered this to replace my OEM CR-10 hot-end. Installed flawlessly. Prints come out perfectly. However, within a week, one of the fans started whining like a bearing was going bad. Did not affect the quality of the prints, but I was concerned that I may lose the fan. Contacted the seller to find out if the fan was replaceable and if so, would they send the fan. They sent me an entire new hot-end kit to test. They were very quick to respond and very helpful.
jrread07
Comentado en los Estados Unidos el 7 de abril de 2022
I have been battling 3d printer problems for about 6 months with my Creality CR10S. With frustration to the max I decided to replace this whole assembly. OMg I am so glad I purchased this! Removal and installation was easy with the directions, if you have a 3d printer I am sure you are capable of doing it without them. The fans are back to whisper quiet, prints are beautiful and no issues since the quick and easy install (maybe 10 min). I love the new tube system with the higher quality tubing allowing it to not get so hot and stretch causing bulging and blockage. Don’t wait and think longer, order and be back to printing. I think I have done 2 dozen perfect parts since install with no glitches…..why did I wait so long.
Henry J Moreland
Comentado en Australia el 9 de mayo de 2021
It was as described and works well.
Productos recomendados