No hay artículos en el carro
No hay artículos en el carroExtrusora de doble engranaje para impresoras 3D Creality Ender 3 V2 Neo/Ender 3 Neo/Ender 3 Max Neo/Ender 2 Pro
Ebrahim
Comentado en los Estados Unidos el 25 de febrero de 2025
I have an Aquila x2 which is essentially an ender 3 clone. I bought this to get rid of occasional filament getting stuck.This was not a sane buy. I have had trouble trying to find information about this item.Sure the pro version has a lot more.information but not this per se.Installation was not that difficult. I also took the time to change the wheels and some belts, bed screws, nozzles, springs etc.I adjusted the gcode and the slicer retraction settings.And since tried many different settings as wellMy issue is that the extruded filament is very stringy and has no strength. It is very brittle.This suggested retraction issues but I have tried many retraction settings and can't seem to get it to work.After 2 weeks of trying I replaced with the previous extruder and gears and then bought another 3d printer from Amazon since i really wanted a direct drive .
Lee
Comentado en los Estados Unidos el 16 de febrero de 2025
This works great on my Ender 3 v2. I would say that it's the best upgrade I have done so far. I printed a bracket to hold a tube from my filament dryer to the top support, then let the filament drop direct into the extruder. It now feeds clean, has less retraction, and allows more precise prints. After months of printing with this I don't see any extra wear on the gantry rollers either.
Travis Garrett
Comentado en los Estados Unidos el 26 de abril de 2025
I put this part on my old Ender 3 as a part of my upgrade for it. Now printing is much easier and my prints look alot better with direct drive!!
Steve
Comentado en los Estados Unidos el 23 de diciembre de 2024
Although the direct drive is easy enough to install, there is a smal but important lack in the documentation. With sonic pad/klipper the adjustment is in rotational distance not E-steps. Not sure if this same hols true for any other firmware but it's definitely something important to note.
Cliente de
Comentado en México el 19 de abril de 2024
Lo instale en mi impresora Ender 5 plus y no tengo ningún problema de atasco en el materia
Trace
Comentado en los Estados Unidos el 22 de septiembre de 2023
No se pudo cargar el contenido.
Productos recomendados
Mex $745.87
Mex $ 402 .00 Mex $402.00
Mex $341.77
Mex $ 184 .00 Mex $184.00
Mex $275.49
Mex $ 137 .00 Mex $137.00
Mex $413.51
Mex $ 186 .00 Mex $186.00