No hay artículos en el carro
No hay artículos en el carro Parámetros para Creality Ender 3 V3 KE G Senor Kit de sensor de compensación de vibraciones
Rango de medición: +/-16 g.
Protocolo de comunicación: SPI e I²C
Resolución: 13 bit
Consumo de energía: 0.1μA ~ 23μA
Rango de voltaje de E/S: 1,7 V ~ V.
Temperatura de funcionamiento: -40℃~+85℃.
Peso neto: 40 g.
Peso total: 100 g.
Dimensiones de producción: 24 x 19,5 x 9 mm.
Tamaño del paquete: 150 x 110 x 45 mm.
Van
Comentado en los Estados Unidos el 9 de enero de 2025
these are legitimate Creality branded hardware and are great for reducing VFA ringing on your bed or hotend. I am using this as a second sensor for my Creality Ender 3 V3 KE printer. I have mounts attached to my bed and to my hotend and I keep sensors mounted there so I can pull out the cable that came with my KE to run the input shaper macro as needed when things shift slightly and the compensation needs to be adjusted.
Kellie
Comentado en los Estados Unidos el 4 de abril de 2025
Nice add-on to the Ender 3 V3 KE that I bought. Helps with some of the fine tuning. You can easily find the print file to attach it to the printer.
ElevatedMugetsu
Comentado en los Estados Unidos el 12 de agosto de 2024
Well after printing the mounting bracket for it, I was able to get it hooked up and ready to use. The instructions in the box actually showed the bracket but it did not come with one though. It seems to have helped a bit more but will update my review after more use.
Sebastian
Comentado en los Estados Unidos el 5 de julio de 2024
Installation manual shows a mount used with the included screws to connect the sensor to the X-Axis. It did not come with the necessary mount. I'm assuming they think you can print it? I couldnt find the model on Creality's site though :(
Jerma Panda
Comentado en los Estados Unidos el 15 de noviembre de 2024
Make sure you have two sided tape. It sure did shake. I definitely see better quality print on the few things I have printed so far that are repeats. From what I have researched, it’s doing a good job at ringing. It’s easy to gather the data on the 3v3KE with the ubc port on the back of the screen. I’m still pretty new to 3-D printing.
Productos recomendados
