No hay artículos en el carro
No hay artículos en el carrobburnard
Comentado en los Estados Unidos el 28 de febrero de 2025
This is a great upgrade! It improved my bed leveling and print quality and easy to install. This one couldn't connect to the original Z cable, so you will have to open up the bottom and run the cable to the mainboard. But hey, you've got an Ender, you're a pro at taking it apart by now!
Ahmed Raslan
Comentado en Canadá el 10 de febrero de 2024
This second z axis completely changed the quality of my prints! I have a creality ender 3 pro and was always bugged because the x axis was crooked. With this support on the other side the problem was solved. A little bit tricky to install but there are bunch of tutorials on YouTube that will show you exactly what to do.
MDR Innovations
Comentado en Canadá el 20 de agosto de 2023
Installed on ender 3 max with 500mm z rods
Adam
Comentado en Canadá el 7 de noviembre de 2023
The kit doesn't work for the Ender 3 Max, as the lead screw is too short, however the mounts and accessories fit. Had to buy a separate lead screw that was longer, but once I did that, it fit beautifully. Was easy to assemble, despite there being NO instructions in the box whatsoever. Thankfully I found a video to confirm my steps, but bags were not numbered, and mostly labeled in Chinese.Just make sure when installing you watch a YouTube video to confirm your steps, and when dealing with the concentric nut, make sure it goes back in the right way or your pom wheel won't work.
Mario Cesar
Comentado en México el 21 de enero de 2023
Tenía problemas de nivel cuando solo tenía 1 eje y constantemente se caían los soportes, eso acabó con un doble eje z, si comprás la ender 3 DEBES comprar esta actualización.
Stephen
Comentado en los Estados Unidos el 16 de diciembre de 2022
This was very easy to install. the instructions are horrible as with nearly every creality product, but if you can build one of their printers you can figure out how this should go on.After install my print quality wasn't quite right (small amount of bed adhesion issuses)after squaring the x axis and tightening the concentric nut, my printer is working flawlessly and can hold the weight of a direct drive system (whole reason I bought this was for holding the weight)
Arturo
Comentado en México el 6 de noviembre de 2022
No se pudo cargar el contenido.
Productos recomendados