No hay artículos en el carro
No hay artículos en el carro Cinturón de apertura de goma con hebilla de cobre
Tipo: 2GT
GT2 Paso: 2 mm.
Altura del cinturón: 1,38 mm.
Altura del diente: 0,75 mm.
Material: hule
Longitud del cinturón del eje X: 765 mm.
Longitud del cinturón del eje Y: 720 mm.
Ancho: 6 mm.
Forma: correa dentada abierta.
El paquete incluye: 1 cinturón de 3 ejes
1 correa Ender 3 ejes Y.
Ashley Lynn Johnson
Comentado en los Estados Unidos el 1 de febrero de 2025
Had to return a set because it broke it a day and got another one, now it's too short for my machine. It fits but I guess quality control is just awful.
Cal
Comentado en los Estados Unidos el 7 de enero de 2024
Pain in the neck to change due to machine design, but it seems to be a good fit so far. Got 2 years out of the last one. Hoping for same or better from this one.
Customer
Comentado en los Estados Unidos el 16 de enero de 2024
These are made for the end three, but I’m using it with the V2. So it took a little bit of doing, but after printing a spacer from thingy verse, everything worked fine. You will need a spacer for the Y axis belt if you are going to use this an Ender 2 V2.
Marco
Comentado en México el 25 de marzo de 2023
Medidas exactas buena calidad buen producto
Barry
Comentado en los Estados Unidos el 16 de enero de 2023
Replacement for broken belt on Ender 3 Pro. Original broke at fitting end. I would think that Creality could design a better way to attach the belts but in all fairness, I had several hundred hours on the orginal belt.
Karen Petrucelli
Comentado en los Estados Unidos el 6 de diciembre de 2022
After several years of faithful service, the X-Axis belt on my Ender 3 Pro broke. I ordered up a set of these belts and they arrived a couple of days later. Looking on line for install instructions yielded two options - snake the belt on using needle nose pliers or taking the bed off. After 15 minutes of utter frustration with the pliers, I simply removed the bed leveling knobs and lifted the bed up and out of the way. You do you, but I would take the bed off. So much easier. I had read some reviews that the X and Y belts were labeled wrong. In my instance, they were labeled correctly. X-Axis on the bed and Y-Axis on the extruder. It's been a few days of near constant printing and no issues to report.
Samuel OS
Comentado en México el 6 de enero de 2022
Tenia mis dudas pero cumplió el objetivo, solo he usado X y ajustó perfectamente.
DanTre
Comentado en México el 22 de abril de 2022
La publicación hace mención que viene con las bandas para los dos ejes, pero solo llego una banda, solo porque ya me urgía una no metí el reclamo.
Productos recomendados
Mex $648.59
Mex $ 350 .00 Mex $350.00
Mex $443.29
Mex $ 217 .00 Mex $217.00