Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

DROK - Medidor de batería de 48 V, 2 unidades, 10-100 V, capacidad de la batería de 12 V, 24 V, batería de litio, indicador de temperatura Fahrenheit

Envío gratis en pedidos superiores a Mex $600.00

Mex $607.03

Mex $ 273 .00 Mex $273.00

En stock

1.:12v ℃


2.Color:Negro -


Acerca de este artículo

  • Tipo de batería aplicable: el monitor de batería digital DROK es adecuado para batería de litio de 10 a 100 V (12 V, 24 V, 36 V, 48 V, 60 v), batería de plomo-ácido, batería de fosfato de hierro y litio, batería Ni MH.
  • Aplicación: se puede utilizar como medidor de voltaje de la batería y probador de capacidad de la batería para coche, marino, RV, barco, etc.
  • Medidor de temperatura en F. --- El indicador de temperatura se puede mostrar en Fahrenheit. (Nota: la temperatura no es el aire, sino la temperatura interna del medidor)
  • El 1 que quieres: fácil de instalar y usar. Te permite programar el porcentaje con un voltaje correspondiente.
  • Predeterminado: batería de plomo ácido de 48 voltios.


Parámetros: Voltaje de funcionamiento: 10-100 V. Consumo de energía: 8-10mA (luz de fondo encendida) Rango de medición de temperatura: 17.8-180 F Características: 4 en 1 metro: no solo puede mostrar la capacidad de la batería y el voltaje, sino que también puede mostrar la temperatura Fahrenheit o Celsius. visualización de temperatura: la temperatura Fahrenheit y Celsius está disponible, se puede cambiar fácilmente con la llave. Encendido/apagado: diseñado con el interruptor de encendido/apagado, conveniente para el uso diario. Información sobre tallas: Tamaño del producto: 61,5 x 33,5 x 13,5 mm. Dimensiones de instalación: 58,5 x 28,5 mm. Tamaño de la visualización: 33 x 16,5 mm. El paquete incluye: 2 medidores de batería de 48 V.


gerry lemyre
Comentado en Canadá el 13 de abril de 2025
Good
ねこネコ猫
Comentado en Japón el 22 de marzo de 2024
メーターの誤差は±0.8V位、負荷をかけると誤差はなくなる(今の所)使いやすくコスパもいいのでお勧めです。
Ledesma
Comentado en los Estados Unidos el 20 de octubre de 2024
Was very simple to install. Temp sensor is kind of short, but was able to run it out next to a light switch under the cabinet. I love that it can be turned off to not waste power. No more guessing. The old battery indicator only stated "weak, fair , good charging"
Joel Chavez
Comentado en México el 27 de septiembre de 2024
No sirve el indicador de carga
Mike
Comentado en los Estados Unidos el 28 de marzo de 2022
I really like the look and features of this battery meter.As has been commented on before, the gauge of wire is very thin and does feel flimsy. I tried making this better by stripping the wires for an inch or so, then folding the bare wire in half and twisting it together. Next, I tinned the wire ends with solder and then crimped them onto spade terminal connectors. In addition to crimping the wire ends to the terminal connectors, I also soldered them to the connectors to insure stable electrical contact. I crimped the corresponding female connectors to the positive and negative wires behind the dashboard of my golf cart. To strengthen the connections, I applied heat shrink tubing to the wiring on each end and fitted it to snugly abut the terminal connections both male and female.I then enlarged the already existing meter hole to accommodate the dimensions of the new meter. I did this by first cutting out a template using an index card, which I aligned and taped to the dash where the meter will reside. Using the template, I cut the hole using a hack saw blade and did finish trimming with an Exacto knife.Finally, I plugged the spade connectors together - positive to positive and negative to negative. I used more heat shrinkable tubing to completely cover up and protect the point where the male and female spades are connected. This guaranteed the connect would never accidently disconnect.I then programmed the meter to correspond to the type and voltage of my golf cart batteries. However, when I turned on the display, it shows that my brand new (two-day old), fully charged batteries are at 77% of capacity. It should read near 100%. I’ve asked the seller for assistance to resolve the problem. The seller promptly instructed me to use menu item 3 to customize the minimum and maximum voltage of my battery array. I did what they instructed and that resolved the issue.The finished installation looks great and the meter seems to operate perfectly.
Angel L. T.
Comentado en México el 17 de abril de 2022
El medidor ya venía configurado para baterías de 48 V de ácido plomo, así que solo tuve que ponerlo.Además vienen varias opciones de configuración por si lo quiero usar después con alguna otra batería.El display en luz de día no se ve muy bien pero se puede ver.Un buen producto por el precio.
john cousland
Comentado en Australia el 1 de agosto de 2021
i am using this in my 4wd to give me an accurate reading on my deep cycle battery
Productos recomendados

Mex $3,750.00

Mex $ 1,725 .00 Mex $1,725.00

4.4
Elegir

Mex $148.81

Mex $ 86 .00 Mex $86.00

4.7
Elegir