Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Eightwood - Conector macho de crimpado BNC de 50 ohmios para cable RG58 RG142 LMR195

Envío gratis en pedidos superiores a Mex $600.00

Mex $411.79

Mex $ 201 .00 Mex $201.00

En stock

1.Color:Bnc Hembra


Acerca de este artículo

  • Conector de crimpado macho BNC de montaje de cable. Impedancia: 50 ohmios
  • Los conectores están hechos de latón (no aleación) para mayor durabilidad mecánica y conexión sólida
  • Funciona con cable coaxial: RG58, RG142, LMR195
  • Adecuado para hacer montaje de cables para aplicaciones de RF de 50 ohmios, incluyendo antenas, radios aficionados VHF UHF CB, escáneres de radio, cámara de seguridad, analizador de espectro de osciloscopio, probador de cables, sensor inalámbrico, etc
  • Contenido del paquete: 10 conectores macho RG58 BNC + 10 tubos termorretráctiles



Descripción del producto

Opiniones de los clientes
4.2 de 5 estrellas 29
Precio no data no data
Tamaños en troqueles 0.08 pulgadas, 0.08 pulgadas, 0.12 pulgadas, 0.25 pulgadas, 0.25 pulgadas 0.028'',0.039'',0.047'',0.100'',0.128'',0.151''
Grupo de cables RG58 RG142 RG62 RG62 RG174 RG316 LMR100 RG316 RG174 RG178 RG178 RG179 RG180 RG187 RG196

Daryl Reimer
Comentado en los Estados Unidos el 14 de abril de 2025
I was wanting to install both the female and the male fittings on RG400 coax.... Vendors seldom mention RG400.And going on the assumption that if it works for RG58 then it will work for RG400 is bad logic I'm told... HOWEVER... I installed both the male and the female units on RG400 and it worked great.... the collar fittings are a little tight over the back of the fitting but that's the way you want it to be... DO NOT crimp the little center pin... male or female version.... there's a little hole that will wick the solder into the hollow of the pin... this soldering is easy peasy... just get some really small diameter solder... soldering tip (really important) ..squeeze or bend the center pin a little bit so the center wire so it doesn't move around while you touch it with the soldering iron.. it doesn't take much solder...These are quality fittings and they work well on RG400
Mark C.
Comentado en los Estados Unidos el 16 de junio de 2024
Ordered a pkg of these connectors to repair a damaged connector on RG 58 cable. I recommend practicing on an old length of cable, as it is VERY important to get the assembly and crimps correct. (YouTube videos are a great help.)If the connections aren't correctly done, the signal through the cable will be weak or non-existent. Also, be sure to check continuity after assembly, to double check that you've done it right. Continuity reading of 1 or less is ideal. These parts worked great & since there's 10 in the pkg, you have extra to practice on.
michel chouinard
Comentado en Canadá el 6 de mayo de 2024
Good value
Ted
Comentado en Australia el 25 de marzo de 2024
The quality is better than most on the market, ideal for Amateur Radio requirements for 50 ohm fast shipping and great seller
Cott
Comentado en Canadá el 24 de marzo de 2024
These work as they're supposed to. You'll need a crimping tool to install properly, one that can crimp both the metal collar and the centre pin. Without one they are difficult to install properly.
Productos recomendados

Mex $199.34

Mex $ 119 .00 Mex $119.00

4.4
Elegir

Mex $487.10

Mex $ 243 .00 Mex $243.00

4.7
Elegir