No hay artículos en el carro
No hay artículos en el carroOwe N Thoresen
Comentado en los Estados Unidos el 26 de febrero de 2025
All good
W.K.
Comentado en los Estados Unidos el 11 de enero de 2025
I needed it for a computer control project and it worked nicely.
José F.
Comentado en México el 9 de julio de 2024
No da las rpm qué prometen, es muy baja su velocidad incluso sin la caja reductora, le realice varias pruebas con su caja reductora y sin ella, el puro motor sin caja reductora no alcanza buena velocidad, parece más un motor de 100 rpm qué de 300 rpm.
Alejandro Sanguino
Comentado en los Estados Unidos el 19 de noviembre de 2024
El producto llegó muy rápido y es de buena calidad
A. Sharikov
Comentado en los Estados Unidos el 18 de noviembre de 2022
Good motor, works as expected. I use it for my small robot. Encoder works fine too. Company provides a code for Arduino in C++, which handles encoder data and controls motor with motor class. This code contains PID controller lines, but I am not using this. I modified this code for my needs, but I did not change a core part about encoder which works fine. Finally: this is a good motor. It can be used to drive small robot. Maybe RPM is high for this, but it is acceptable for small carts.
Kevin Fox
Comentado en los Estados Unidos el 25 de diciembre de 2021
I needed a gearmotor with positional feedback for an automated roller blinds project, so I bought one of these motors for testing. The motor works, and it's performing at an acceptable level. I was able to successfully read positional feedback with a micro-controller. The noise level is somewhat normal for a DC motor of its kind, not silent but not loud. I'd say it's similar to pololu's 25D LP 12V 33RPM gearmotor, but with 75% of the torque at any given current level.My test setup is pictured here. At zero load, the motor draws 12V 50-60mA. When hoisting the 361g measuring tape over a 48mm diameter wheel, it draws 12V 110-120mA. I'd estimate that it draws 12V 0.45A - 0.6A at the rated load in the description (4.5 kg*cm). It's not a bad idea to have a buck/boost converter with a current limiter set to ~0.45A, so that your motor won't burn itself out in case of a stall.
Productos recomendados