No hay artículos en el carro
No hay artículos en el carro/
Musa Wilmar
Comentado en los Estados Unidos el 12 de marzo de 2025
Nice.... strong hot end for my sovol
Andre Guerrieri
Comentado en los Estados Unidos el 11 de febrero de 2025
These nozzles are working great so far I'm SV08. I really like the ability to swap nozzles. Just make sure you tune your slicer for the hardened steel nozzles. You'll be running about 10° hotter on PLA. I haven't tested ABS yet since I didn't have an enclosure yet.
John P Ayers
Comentado en los Estados Unidos el 18 de enero de 2025
I installed this last night and have had a few successful prints today using PLA and PETG. I had to recalibrate and do a new temp towers. Seems like about 5 - 10 degree increase in temp was needed to get same results as the stock nozzle. Looking forward to playing with my CF now! Easy install.
ian Two
Comentado en los Estados Unidos el 15 de enero de 2025
Threaded part is nice so the nozzle doesn't get up and leave, but both hardened nozzles were junk. One was full of corrosion and the other produced absolutely terrible prints. Switched to a microswiss and would recommend putting this $30 towards that instead.
Operation: Man Cave Freedom
Comentado en los Estados Unidos el 13 de abril de 2025
Came with some glue for refueling the heater back on around the hotend. So far so good and will update later if there is ever a failure or leak problem like there was before with my T300 printer. Functions greats with all the typical filaments. Will be testing with CF nylon here soon. Standby for updates.
Productos recomendados