No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Material altamente duradero
Silicona de alta calidad, ayuda a reducir la vibración.
Tamaño adecuado
Tamaño adecuado para ayudar a nivelar sus impresoras 3D más fácilmente.
Cantidad suficiente
8 piezas en el paquete, pueden satisfacer tus diferentes necesidades y reemplazos diarios.
Carolina
Comentado en México el 27 de marzo de 2025
Las utilicé una una Anycubic Kobra 2 Max y quedaron bien, a los del centro de la cama tuve que colocarles unas rondana porque esos deben de ser un poco más largos. Pero con esa solución lo pude utilizar en los 8 puntos que tiene la cama
neCARmancer
Comentado en los Estados Unidos el 7 de agosto de 2024
I’ve been fighting with the springs for a couple of years now. These work so much better and don’t shift in the middle of a print like the springs keep doing.
Alvin
Comentado en los Estados Unidos el 11 de agosto de 2024
Bought these silicon levelers to replace the springs that came with my kingroon kp3s headbed. The spring were super inconsistent and wouldn't stay level all the time. These silicon feet work great and the various sizes allow me to mix and match where my headbed was very uneven.
Hatch
Comentado en los Estados Unidos el 12 de junio de 2024
The silicone spacers are so much better than springs for leveling your bed. This is the first time I've ever used them and I'll never go back to springs.Note: the original spacer was not long enough. It didn't provide enough height to raise the bed high enough to reach the nozzle. Luckily they sent 8 spacers. I used scissors and cut a couple spacers in thirds...adding a full spacer and a 3rd of a spacer. That did the trick. You can see in my pictures the 2 spacers.Leveling my bed was so much easier and quicker than when I did it with the springs. The bed also feels more stable and secure than it did on the springs. Printer manufacturers should just ditch the springs all together and go with silicone spacers.I bought the cheapest spacers I could find on Amazon. There's no reason to spend more... they're all made of the same thing and perform the same. I was worried they would be too stiff and not compress any when lowering the bed but the spacers are perfect. They have a little bit of flex in them so they will squish down a little bit when you lower the bed to level it.
Drew
Comentado en los Estados Unidos el 26 de diciembre de 2024
These represent a very simple and affordable way to improve your bed leveling.
Kevin R.
Comentado en los Estados Unidos el 5 de septiembre de 2024
I have had an AnyCubic Kobra Max for 2 years and recently needed to print something using almost the entire bed for a project that needed a perfect first layer face. My bed var was .85 with aluminum bed and G10 Garolite sheet. I disassembled the entire x axis sled and replaced the horrible metal spacers with these rubbers ones. My bed uses 2 different sizes, shorter inside and longer outside bushings.After doing this and spending some time and leveling, then using Octoprint ABL....many times, I finally got my bed Var down to .18 and I got a huge perfect first layer.Since then I got a P1S AMS, so I haven't used my Kobra much.I don't really see these being much better than stock bushings if you have them, I only needed them because I had solid metal bushing. Poor design choice on Anycubic's part.
Productos recomendados
Mex $136.00
Mex $ 76 .00 Mex $76.00