No hay artículos en el carro
No hay artículos en el carroIdeaFormr-3D Smooth PEO+texturizado PEI Build Plate para Creality K1C/K1/Ender 3 V3 SE/Ender 3 V3 KE/Ender 3 S1/Pro/Ender 5 S1, hoja de acero flexible PEO PEI de 235 x 235 mm, sin placa de superficie magnética
mnq
Comentado en los Estados Unidos el 4 de enero de 2025
I print a lot of large pieces and these plates are fantastic. ABS sticks like glue (minus glue) and every type of PLA sticks to the smooth side with just a light rubdown of glue (3D printer specific). The smooth side leaves a pattern on the prints that just looks cool so you have functional, and fun 🤩.I bought two because as soon as one job ends I just swap the plates and run the next batch. Never had any issue with release either if you take the time to let the plates cool (which is the reason I bought two).Will 100% buy these again but after almost 100 prints they show zero wear so I don’t see needing to replace these anytime soon.For specifics I use these on an Ender 3 v3 Plus running anywhere between 65 and 100 degrees for the bed temp and 275mm/s to 600mm/s speeds.
Geobig
Comentado en Canadá el 25 de enero de 2025
Good quality product. Works better then the original Creality build plate nice to have the PEO side for PLA prints that need a smoother bottom layer.
JT
Comentado en Canadá el 16 de abril de 2025
Worked for my sons 3d printer
Jos
Comentado en México el 27 de agosto de 2024
No se pudo cargar el contenido.
Matt E
Comentado en los Estados Unidos el 17 de junio de 2024
UPDATE: Seller reached out very quickly, and shipped me out a new sheet immediately. So far so good. The new sheet feels different versus the first one I received and prints are coming out FLAWLESS. Updated review from 2 Stars to 5 Stars. Thank you!At first, adhesion was fantastic. 5 prints later, nothing was adhering. I figured, it’s got to be my bed level. Retrammed the bed, everything was fine, then I thought about cleaning the plate, used a small drop of dawn and a microfiber cloth, cleaned it, washed it, let dry, used 99% IPA to clean off any mineral deposits or water/soap residue. About 10 failed prints later, I decided to check bed level, Z-offset, everything. Eventually, I got adhesion but only after my nozzle dug into the PEO side. So now I only have the textured side. It's adhering (for now)...
allan
Comentado en el Reino Unido el 1 de noviembre de 2024
No se pudo cargar el contenido.
Productos recomendados
Mex $459.97
Mex $ 211 .00 Mex $211.00
Mex $619.32
Mex $ 334 .00 Mex $334.00