No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Soporte de TV con inclinación para Pantallas de 32”-84”
Material reforzado, estructura de carga estable
Instalación simple, con tornillos de instalación
La instalación es muy simple, también puede instalar rápidamente el televisor en la pared como un instalador profesional, con suficientes tornillos de diferentes especificaciones para que pueda instalarlo más fácilmente.
Javier Contreras
Comentado en México el 14 de marzo de 2025
Me funcionó muy bien para un tv de 70".
Eduardo Jesús
Comentado en México el 23 de diciembre de 2024
Llegó en el día indicado pero un detalle llegó sin el instructivo para poder colocarlo
Che Rubens
Comentado en los Estados Unidos el 29 de abril de 2024
Easy to install and comes with everything is needed
Linda
Comentado en Canadá el 8 de febrero de 2023
very dispointed in purchase it is still not assembled
Mark
Comentado en Canadá el 29 de abril de 2023
Fit perfect for my daughter's 32 inch tv in her room. Came with all the needed hardware too.
BShap3
Comentado en los Estados Unidos el 20 de agosto de 2020
Solid, inexpensive TV Mount. I just used it to mount a 24" Vizio to my wall. The mount is small, only 11" wide, and most houses have wood studs every 16" apart, so you can't drill this into two studs. I used 6 drywall anchors (very easy) and it feels completely solid. This was definitely a good purchase; Best Buy's only option was an $80 mount and there's just no reason to spend that sort of money. The only downside here was that the instructions were quite difficult to decipher; it took a lot of squinting. However, there are only like 8 pieces total and it wasn't that hard.One other note: it is pretty easy to take the TV on and off the wall, which is useful for tinkering with cords or whatever.
DexterW
Comentado en los Estados Unidos el 14 de enero de 2020
Bought this for my Acer 32" curved monitor. As others have said the instructions are pretty awful, but if you stop and think about the very few pieces it's not hard to figure out. For example, the swivel brackets. The adjusters need to be on the outside of each so you can easily adjust once the monitor is up on the wall. So I noticed the square key on the bolt head and figured that must fit in the square hole of each swivel's outer sides. Correct!This is clearly meant for a TV and not a monitor, but I still got it to work. The VESA mount on my monitor is inset 1/8 inch for the monitor stand. Once I removed the stand, these swivel mounts don't sit properly on the uneven VESA mount surface. Fortunately they provided lots of washers and I used them to build up the uneven monitor surface so the swivel arms could attach flat to the back of the monitor. Not how I envisioned using washers, but whatever works right?The guy that complained about "bracket built backwards" needs to use the long set-screws to secure the bracket. Also, the second bracket needs to have the adjuster screw on the opposite side. His picture shows each on the same side. Believe me, I saw his problem immediately because I almost did it too.Even with the awkwardness, definitely worth the purchase for me. Inexpensive, works well, and hangs perfectly even.
Productos recomendados
Mex $1,990.00
Mex $ 796 .00 Mex $796.00
Mex $149.00
Mex $ 83 .00 Mex $83.00
Mex $611.01
Mex $ 336 .00 Mex $336.00