No hay artículos en el carro
No hay artículos en el carro Ventaja:
Hecho de material de alta calidad.
Probado y certificado para cumplir o superar los estándares de calidad OEM.
Compatibilidad:
Bronco 1996 Bronco 1980-1985
1980-1983 F-100
1980-1997 F-150
1980-1997 F-250
1980-1997 F-350
Incluye:
4 pines para bisagra de puerta.
8 bujes de puerta
8 clips de anillo electrónico
Garantía:
El kit de pasador y buje de bisagra de puerta viene con 12 meses de garantía.
Política de devolución y reembolso sin complicaciones.
Cómpralo con tu confianza.
Michael J. Cimorelli Jr.
Comentado en los Estados Unidos el 9 de febrero de 2025
These are awesome. I’ve used the main aftermarket brand several times on my 97 F250 and the bushings would always wear through. This kit appears much stronger, I also used grease - the 4 pack gave me some extras.
CmanXirone218
Comentado en los Estados Unidos el 3 de junio de 2024
The product page says these will not work on the Ford ranger, but I installed them in the door hinges of my 1991 ranger and they were a decent fit. I did have to fight to get the hinge apart but these are a direct replacement/rebuild for the pre 1993 rangers and probably bronco II! Not sure about newer rangers but older ones most definitely!
Bradley M.
Comentado en los Estados Unidos el 23 de junio de 2024
Pretty much the same thing you get from Autozone/O'reillys but half the price. On my extended cab f150, these were much easier to do than I thought. You can absolutely do them one hinge at a time without disconnecting any wires/anything else. Just be sure to support the door when you pull the pins out, I used a jack with 2 2x4's wrapped in a old towel. The door wont move too much though if you do one pin at a time, unbolting the hinge from the door. Die grinder or Dremel works best for removing the heads of the OEM pins, they're just mild steel. Make sure you have the heads completely off before you start trying to punch them out, You'll see a distinct circle around the pin when you've gone far enough. I went from about 2 or 3 inches of door sag to about 1/2 of an inch. Well worth it for the price.
will pruitt
Comentado en los Estados Unidos el 22 de septiembre de 2024
Bushing could be a little tighter
Anibal
Comentado en México el 6 de mayo de 2023
Seven de buena calidad para ford f150 93
Scornejo
Comentado en México el 23 de mayo de 2023
Justo lo que necesitaba gracias
Francisco Javier Trujillo Mancera
Comentado en México el 26 de marzo de 2023
Para restaurar mi pick up
JESUS
Comentado en México el 23 de marzo de 2023
excelente
Jaime l.
Comentado en México el 29 de noviembre de 2023
Son los pernos justos a la medida.
Kevin Mc.
Comentado en los Estados Unidos el 22 de enero de 2023
Nothing really hard about putting the pins in. Bushings are not a real tight fit and will fall out during reassembly. The worse part is pulling old pins and old bushings. I did mine one at a time. Top first then the bottom. Wasn't easy but do-able. I wouldn't attempt to take door off by pins. Because bushings staying in place would be a problem. My doors have wiring going into them. Didn't want to mess with all that. So done 1 at a time.
Eli Granados García
Comentado en México el 19 de enero de 2023
Alejandro Vidal
Comentado en México el 5 de abril de 2023
Exelente
Productos recomendados
Mex $1,810.52
Mex $ 832 .00 Mex $832.00
Mex $833.76
Mex $ 433 .00 Mex $433.00