No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Soporte de clip para fondos y reflectores
Específicamente diseñada para fondos y reflectores plegables, esta práctica herramienta te permite colocar tu equipo de modelado de luz en cualquier soporte que desees para obtener el máximo impacto de iluminación. El sistema de diseño fácil de pellizcar permite una fijación rápida y firme sin molestar con el fondo, reflector o requerir la ayuda de un asistente adicional.
Soporte de disco reflector clip para soporte de luz
Material: Aleación de aluminio con acabado plateado satinado. Peso: 67 g. Ideal para usar sin un asistente. Perfecto para posicionar tus reflectores. Fácil de montar. Fácil de usar
Ale Olivas
Comentado en México el 3 de junio de 2022
En veces lo utilizo para sostener los dibujos de mis hijos, también cumple esa función a la perfección
Loic Pravaz
Comentado en Canadá el 14 de enero de 2018
Will buy again when I need to.
Ronny
Comentado en Canadá el 10 de enero de 2018
quality is ok, very functional
Jill Clardy
Comentado en los Estados Unidos el 7 de agosto de 2016
This simple, inexpensive reflector clamp works perfectly for my application, which is newborn photography. Previously I had to just lean the reflector on the beanbag when photographing a baby, but it was always precarious and would tip over easily. You simply drop the clamp onto the top of a light stand, tighten it with the wing nut, then clamp it on to the reflector. It holds the reflector in a vertical position and is quite secure. You can't really angle the reflector since it hangs straight down, but for my particular purpose that doesn't matter. I'm still looking for an inexpensive boom arm which will allow more precise positioning ft he reflector, but for now I'm really satisfied to have found this little clamp.
Andrew Gooch
Comentado en los Estados Unidos el 21 de mayo de 2015
What you see is what you get with this item. It looks exactly as in the products photos.Initially, when I first opened and inspected the item, I was concerned the wider edge on my 5-in-1 reflector would be too bulky for the clip to properly grip it. The clip does its job just fine and is holding onto my reflector. I did take it outside in the wind to really test it and the reflector stayed on well, the stand did keep blowing over though. I'm sure if I sand bagged the stand it would have stayed up as well, but that's my fault.As has been mentioned in previous reviews, the seams along the plastic show easily, and the plastic is not of the best quality. In the end, it not tasked with a heavy workload, so it should hold up just fine. One thing to note, the clip does not angle at all and stays at 90 degrees, so if you are wanting it to do that, you may be in the market for something else.
Maker
Comentado en los Estados Unidos el 26 de noviembre de 2014
Looks exactly as photographed. Does its job, is holding onto my reflector just fine. Not much to it. Not the most refined item, there are seams along the plastic, and the plastic is not of the highest quality, but it's not doing anything heavy duty. All in all seems good so far. Good service.
Productos recomendados
Mex $324.60
Mex $ 152 .00 Mex $152.00
Mex $305.00
Mex $ 149 .00 Mex $149.00
Mex $409.00
Mex $ 208 .00 Mex $208.00