No hay artículos en el carro
No hay artículos en el carroC²
Comentado en los Estados Unidos el 7 de junio de 2024
Physical diameter was larger than I had anticipated, but that is no fault of the product or seller; I likely overlooked dimensions. The leads are a little thin for my liking but it gets the job done. We'll see how they hold up long term in the Razor Ground Force Drifter cart I installed them in. The contrast of the display is great. It's not overly bright yet easily visible for my daytime usage, though I'm not sure how bright it'd be in a darker environment. Would certainly purchase again.
JimMortgage
Comentado en los Estados Unidos el 16 de marzo de 2024
Installed on my golf cart and it's clear and easy to read. The mount is nice, flush and sturdy. My only complaint is the wire is very thin, so thin I used my finger nail to strip it.
Cory C
Comentado en los Estados Unidos el 6 de noviembre de 2024
Bought this for my golf cart. Wires are very small and a little hard to work with, but installation was pretty easy otherwise. Fit into my existing opening and works great! Highly recommend!
Todd
Comentado en los Estados Unidos el 16 de septiembre de 2024
This is working well on my scooter. I’d recommend these to anyone for smaller vehicles or implements.
Customer
Comentado en los Estados Unidos el 9 de diciembre de 2023
I like the look of this monitor and ease of mounting, and the display looked good for about a second or two before it went blank and never turned on again. The part I received says X003WSH29Z and says 24V whereas the listing part # is B0CD1ZY3NX and says 0-100V. Will send this one back and try again. Get it right next time, guys, if you screwed up.Update: Changed 1 star to 5 stars. Received replacement and this one works. Meter has a good look, display is nice bright green, easy to install. I micrometered the diameter at 1.15 inches, so you'll need a 1-3/16" drill bit. I didn't have that big of a butterfly bit so I used a 1-1/4 inch hole saw. That made the hole a little too big, but I got rid of the slop with an o-ring. It reads 0.1 V too low, but I can live with that if the readings are consistently 0.1 V low .Update 2: I downgraded from 5 stars to 3 stars because now it doesn't increment voltage. It decrements fine under power draw, but I have to cycle the key switch to get it to update to the correct voltage when there's no power draw.
Productos recomendados