No hay artículos en el carro
No hay artículos en el carroPanda Build Plate CryoGrip Pro Glacier Build Plate para impresoras 3D Bambulab P1S P1P X1C X1E A1, hoja de acero con textura fina de doble cara, adhesión firme, 257 x 257 mm
JeepingJohn
Comentado en los Estados Unidos el 6 de marzo de 2025
WARNING: DO NOT BUY! Could not get adhesion with PLA/PETG, no matter what I tried. Plate was clean. Cleaned again, and again, and again. Tried DA, still couldn't get it to adhere. Then I started looking around online for answers. Lo and behold, a multitude of others that had the same complaints. Save your time and effort, DO NOT BUY THIS PLATE!
Haley Wilson
Comentado en los Estados Unidos el 12 de marzo de 2025
Very good build plate. I own the frostbite as well and it does have a bit better adhesion but it can only print pla and petg. It’s got a great texture. I bought it partly because it’s good and because I want to print the airless basketball with biqu’s filament. Amazon sent me a used one which sucked but isn’t the sellers fault and they sent me a free one that is brand new and is amazing
Sean Burke
Comentado en los Estados Unidos el 17 de febrero de 2025
Warping on large prints has been plaguing me for quite some time, and the solution i is not always easy, and varies quite a bit from print to print and brand to brand.As soon as I got this I had to try it out immediately, and WOW! This print in particular, with a wide bottom, tall, relatively thin walls and a large open volume was driving me nuts. But I popped inb the plate, set the bed to 45C, no brim, and it printed flawlessly. I should have bought this plate a lot sooner!
Maverick
Comentado en los Estados Unidos el 7 de abril de 2025
So far so great.Using the basic cool plate settings in Bambu Studio and not a single failure yet.Highly recommended.
Productos recomendados