No hay artículos en el carro
No hay artículos en el carro1.
James
Comentado en los Estados Unidos el 18 de febrero de 2025
Used as a 3d printer bed. Kind of interesting to cut with only a razer blade, but it worked! Not sure if this is quality stuff of not, but I have extra.
RAM1997
Comentado en los Estados Unidos el 24 de enero de 2025
Works great. Prints pop off very easily once cooled. Also, the base layer is much smoother.
J Carlos S Ramos
Comentado en México el 29 de junio de 2024
Excelente producto
Gareth
Comentado en el Reino Unido el 5 de marzo de 2024
It’s my second G10 build plate on a K1 Max and must say it’s chalk and cheese. The other is perfect not adherence issues and glassy finish. No failed prints and I print a lot. This one very poor so I’d avoid this one if you are after G10 for 3D printing. Can return it as had to cut notches for location screws.
KMac
Comentado en Canadá el 27 de noviembre de 2024
So far I prefer it over other beds I've tried.Very small prints stay in place during print.Easy removal of prints after cool down even with large contact areas.
Alien Bitflipper
Comentado en los Estados Unidos el 4 de junio de 2023
This sheet will not magically fix a wobbly, un-level, or warped printer bed (all standard features of the Ender 5 as it was shipped).Printing bed supports, changing from springs to silicone support spacers, shimming the low spot with a piece of foil tape, and then manually tramming the bed made the standard magnetic surface work great with PLA+ / Pro. This plate was still a bit finicky on some prints, but good.On my Ender 5, the CR touch was a total disaster, but switching to a silent board and new Marlin software turned out to be a real winner. After tramming the build plate manually, and adjusting the limit switch for Z axis, the build plate has not required leveling after many prints. This G10 sheet is a strong contributor to that success - it is very repeatable and stable.For me, a nice coating of water soluble hair spray, dried in the oven with its "dehydrate" setting was the final touch. If a print is a bit stubborn, some water makes it fall off. A coat of hairspray lasts several prints.With the small improvements in my lowly Ender 5, and this build surface, printing is reliable and good with no elephant foot.A very worthwhile upgrade for sure, but no substitute for the basics.
Productos recomendados
Mex $2,387.95
Mex $ 1,074 .00 Mex $1,074.00
Mex $315.04
Mex $ 170 .00 Mex $170.00
Mex $502.84
Mex $ 246 .00 Mex $246.00
Mex $1,606.90
Mex $ 707 .00 Mex $707.00