No hay artículos en el carro
No hay artículos en el carroHotend de acero endurecido para impresora 3D X-PLUS3/X-MAX3
Seth Brissey
Comentado en los Estados Unidos el 17 de abril de 2025
I clogged my original hot end after almost a year of use, decided to just get the same thing with a hardened steel nozzle and so far it’s been great. EXTREMELY easy install, and it prints great!
Jerame
Comentado en los Estados Unidos el 15 de febrero de 2024
I recently swapped out my old hotend. The shopping and shipping experience was excellent. Qidi customer support is top notch. I love this printer (Qidi Plus 3)!
Customer
Comentado en los Estados Unidos el 27 de diciembre de 2024
Fits perfectly. These replacement hotends come with the fan on them unlike the ones that came with the printer, makes swapping much quicker. At this price, if one gets clogged I can swap out and carry on.
Walt
Comentado en los Estados Unidos el 9 de noviembre de 2024
First my MCU went out, now my Hot End is down.I've been getting "Heater extruder not heating..." error messages half way through my past few prints. Now its doing it at the beginning. I can't even do a filament change. Qidi Tech tech support is attempting to assist with trouble shooting but waiting 24-72 hours for a response to a response and further instructions is troublesome at best. Especially when you've got prints that needed to be done yesterday. I took a chance and ordered this seeing how Amazon usually can deliver overnight. But this particular Hot End assembly is NOT compatible with the Q1 Pro and Amazon dose not currently (at the time of this review) list a Hot End assembly for the Qidi Tech Q1 Pro so I'm gonna try this other one next: https://a.co/d/1zLmf5s
Steve C
Comentado en los Estados Unidos el 11 de septiembre de 2024
Creators who've always had issues changing out hotends, this hotend (for me and my experiences) was easy to switch out. Qidi copied other designs out there and made it more simple. The ceramic heat cartridge allows for fast ramp up to temp too. I chose hardened steel because I will need to print carbon fiber and glass-filled filaments but.. using hardened steel printing PETG actually dulls that shiney look and my customers love it!Only drawback: Sometimes it's tough to change out filaments that still have a lot of "curve" because the thing is designed with tighter tolerances than most and with that you can get a misalignment between the extruder and hotend due to the gap and if you don't straighten the filament you can jam during a filament change but I've learned some tricks and don't have any issues.Not enuff to hurt the 5 star rating.. I am thoroughly glad I went with Qidi.*Hillbilly Engineer*
Productos recomendados
MICRO SWITCH FINAL DE CARRERA CON RODILLO PALANCA 2.8CM 3 TERMINALES 125-250V 16A, CONTIENE 4 PIEZAS
Mex $129.00
Mex $ 64 .00 Mex $64.00