No hay artículos en el carro
No hay artículos en el carroDescripción del producto
SmallRig Ultra Slim 4K Cable adaptador HDMI (A a A) 3019
Características clave:
1. Cable adaptador HDMI de alta calidad (HDMI completo macho a HDMI hembra) para la configuración de tu cámara.
2. HDMI 2.0 y soporta resolución de hasta 4 K a 60 Hz.
3. Cuenta con dos tornillos de 1/4"-20 para fijar la parte hembra al lado de la jaula de la cámara o soporte en L firmemente para proteger el puerto HDMI de la cámara y garantizar una conexión más estable.
4. Un cable adaptador perfecto utilizado para cambiar el puerto HDMI de la cámara a una dirección más deseada según sea necesario.
Nota:
Asegúrate de que el puerto HDMI de tu cámara sea de tipo Full HDMI.
Esemze
Comentado en Canadá el 27 de febrero de 2025
These things are no good. I ordered two to connect HDMI between my GH5s(s) and Ninja V's and both failed.They intermittently cut out causing missed frames/shots and basically just don't work.Not worth the risk to your footage.
Carlos C.
Comentado en México el 8 de enero de 2025
Funciona de maravilla
Medafilms
Comentado en los Estados Unidos el 10 de agosto de 2024
probado con camara Sony A7IV, funciona como lo describen, aunque el conector que va hacia la camara seria genial que fuese en L
Bill K.
Comentado en los Estados Unidos el 25 de julio de 2024
I am currently using a Neewer Cage, a Sirui handle, and a Smallrig HDMI Adapter. I found that the Neewer clamp did not provide the level of security I was expecting, so rather than purchasing an entirely new cage, I opted for this adapter. It integrates well, with both 1/4-20 threads aligning perfectly on the side of the Neewer cage. I hope this setup helps to protect the port on my FX30. However, one concern I have is that the port faces upward, which may allow rain to enter.
Hal F. White
Comentado en los Estados Unidos el 4 de agosto de 2023
So first off this is always on my camera I think it will save any issues I could have in the future with my HDMI port . I was on a shoot years ago and while on a 16 foot Jib arm a HDMI cable was dangling low and we were not paying attention and it snagged something a ripped the HDMI port out of the camera. We didn’t loose the ability to record but we could no longer see anything on the 17 inch screen. That was a shoot in Ron Jon’s. We still finished the shoot but could not frame our shots. If this was available back then that HDMI in the camera would still be intact. So in my opinion it’s needed. You can see the HDMI cable is pointing up on the left side of the camera. That’s how I have it hooked up and it helps me feel better that this inexpensive HDMI saver is there to protect my camera from and accidental rip out. I wanted to do this review for ages but could. Not as it does not have HDMI in its title. They may sell ore if they did :) highly recommend for your camera with a cage. One suggestion is make it flat and you can select flat front or back or up or down so it has zero stress on the camera as my cable is kinda forced into that position due to the only place I could put this on my camera . I would have chose the up position (in regards to the position of my hdmi port)
Obed Santana
Comentado en México el 19 de agosto de 2022
Podría ser un poco mas largo y con un cable de mas alta calidad. Al doblarlo un poco parece dañarlo. He leido que es incompatible para 4K/60p, pero en una prueba rapida todo parece ir bien, actualizare en caso de que no funcione. Usando con Lumix GH5.
Ryan Allen
Comentado en Canadá el 24 de abril de 2022
Totally fine if you are shooting 10 bit 24 or 30 fps but as soon as you go up 60fps this thing is useless. Clearly speced to get older 1.X HDMI data requirements.
Productos recomendados
Mex $469.40
Mex $ 253 .00 Mex $253.00
Mex $1,580.81
Mex $ 758 .00 Mex $758.00
Mex $209.03
Mex $ 108 .00 Mex $108.00
Mex $375.00
Mex $ 172 .00 Mex $172.00
Mex $239.99
Mex $ 143 .00 Mex $143.00
Mex $122.65
Mex $ 68 .00 Mex $68.00