No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Actualización de optimización de 3 puntos
Actualización de optimización 1 - El enchufe en el adaptador de tubería Starlink versión anterior era de solo 50 mm. Lo hemos extendido a 70 mm, proporcionando una profundidad de anidación más profunda para el poste y el adaptador, asegurando una instalación más segura.
Actualización de optimización 2: el soporte de poste Starlink versión antigua solo tenía tres tornillos de fijación, pero hemos actualizado a seis, asegurando que el poste no gire dentro del enchufe, haciendo que la fijación sea más firme.
Actualización de optimización 3: la versión antigua de la base de montaje Starlink utiliza tornillos para asegurar el plato de antena, lo que podría dañar la superficie de la antena cuando se aprieta. Hemos diseñado un clip a presión totalmente ajustado que se puede enganchar perfectamente, sin dañar el plato.
MJ
Comentado en los Estados Unidos el 5 de marzo de 2025
Using this to mount an outdoor HDTV antenna so it clears the roofline. The kit is perfect for this application, and fits together as necessary. Was easy to figure out and get setup. 5 star product...
Customer
Comentado en los Estados Unidos el 30 de marzo de 2025
A nice sturdy mount system. It dm comes with everything needed to easily install. It has adjustment option which makes it nice as well. I used it to install a regular antenna because of its sturdy functionality.
Tony Parr
Comentado en los Estados Unidos el 26 de marzo de 2025
Works as should, fits 2” pipe and comes with two sets of set screws as needed.
B H
Comentado en los Estados Unidos el 21 de diciembre de 2024
Setup:This stand is able to extend beyond 6 feet high and the height can be adjusted by the top shaft as well as the bottom shaft as the legs come closer together. At first I wasn't sure if this was compatible with the standard gen 3 starlink that is not the mini, but this one is compatible. I had to learn that the kick stands needs to be removed by pulling up on the tab touching the starlink surface with the kickstand flat to remove the kickstand. Once the kickstand is removed I was able to attach the black base to the Starlink device. I like how I can just leave the base attached to the device to set on top of the shaft when needed. It does take a little bit of time to secure the six bolts that secure the base to the shaft, but it's not too bad if you tighten and then loosen just enough to take off. It's also nice how there's a pin that supports the weight of the top shaft and device when you are raising and lowering the top shaft. I wish the chain was a little longer though as it can get in the way. The pin slides through the full shaft giving the shaft a good solid stop from sliding down further.Rotation:The only potential downside worth noting is that when it's fully installed, tightening the knob and/or bolt on the shaft doesn't stop the top shaft from turning the device very well. This may be a good thing if you want it to give a little in a storm, but not a good thing if you are trying to avoid the wind from disrupting the angle of the device.
Productos recomendados
Mex $1,078.12
Mex $ 506 .00 Mex $506.00
Mex $529.99
Mex $ 243 .00 Mex $243.00
Mex $448.00
Mex $ 246 .00 Mex $246.00