No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Acerca del tubo de PTFE:
Alargamiento: 150 ~ 400 %
Resistencia a la compresión: 12Mpa/1740Psi
Temperatura máxima de funcionamiento: 240℃/450°F
Aplicación: Ampliamente utilizado en rieles de guía, aislamiento eléctrico a varias frecuencias. como tubo de transporte de gas y líquido, tubo de revestimiento, tubo de intercambiador de calor, uso en maquinaria, electrónica, válvulas, etc.
Características del tubo de PTFE
1. El tubo de PTFE puede transportar gas o líquido a altas temperaturas.
2. El PTFE es un buen material aislante eléctrico con resistencia al calor.
3. Tiene buena resistencia al envejecimiento, no pegajosa, transporte suave de gas y líquido.
4. El PTFE es un material que reduce la fricción y autolubricante con un bajo coeficiente de fricción y buena lubricación.
Gary B.
Comentado en los Estados Unidos el 14 de marzo de 2025
Good for my 3D printer and correct size ID and OD. Can see the filament inside to gauge placement. Much easier than shining a light through the tubing to see if filament is in that section.
Stan Aksentsev
Comentado en Canadá el 25 de julio de 2024
This charred and dripped when a flame was applied. PTFE does not do this.
Heather M.
Comentado en Canadá el 10 de julio de 2024
Would buy again
Thinh Nguyen
Comentado en los Estados Unidos el 28 de febrero de 2024
Lot of reviews saying this is not good for 3d printing.I purchased this since I needed longer PTFE tubes than I can buy from Bambu Lab.I use this for my all of my Bambu Lab printers, and it works just fine. No issues with stuck filament or breakage inside of the tube.I think translucent looks better and also helps in diagnosing issue caused by filament as you can see the filament better than white ptfe.It does come wound up pretty tight, but almost all ptfe tubes from amazon come wound up pretty tight. You'll want to straighten the tube before connecting it to the printer.
Robert Wright
Comentado en los Estados Unidos el 28 de noviembre de 2023
FYI - I ordered six of these clear PTFE tubes. My 3D printer (Bambu Lab X1C) is very sensitive to the friction of the filament going through the PTFE tubes so I ordered these tubes .5 mm larger than what came with the printer. Four of them worked great but two of the six were unusable because the tube was severely "kinked" when it arrived. The kinked spot caused extra friction, thus they were not usable for my purposes.
Productos recomendados
Mex $92.00
Mex $ 55 .00 Mex $55.00
Mex $108.62
Mex $ 61 .00 Mex $61.00
Mex $58.72
Mex $ 34 .00 Mex $34.00
Mex $77.90
Mex $ 40 .00 Mex $40.00