No hay artículos en el carro
No hay artículos en el carroW11036930 W11316256 Válvula de agua para lavadora
Gordon
Comentado en los Estados Unidos el 23 de diciembre de 2024
Easy to install
Ron B.
Comentado en Canadá el 10 de octubre de 2024
Ordered this part as a replacement for the valve that had broke. This valve was literally a 5 minute repair and solved the problem! Washer works again!
Jeff Bragg
Comentado en los Estados Unidos el 9 de enero de 2024
Fast shipping, meant washer was only down a couple of days. 4 year old Amana frontloader Model NFW5800HW0 had LO FL issue with the old part like this labeled W11036930. I ran a cold wash and it faulted out immediately and you could see no cold water was flowing. Ran a hit wash and hot water valve was working but it faulted once it wanted cold water for the rinse cycle. I had good flow to the washer and a clean screen so this was the next obvious part that controls cold water flow.This one shipped fast and was not super hard to install. Take top off and you will see the two small hoses, the retainer screws and the large water inlet hose. Turn this whole valve about 90 degrees and reverse process to reinstall.Valve works great and LO FL is solved! Highly recommended!!
BOB
Comentado en los Estados Unidos el 15 de enero de 2024
It’s very important to remove the old part before completing your order. By removing it first you can look closely at the part you need and the one you are ordering. I cross reference the part from factory parts search and then search it on Amazon comparing prices and reviews. Look closely at all angles available and compare to what you need. If the plug looks right and the value looks right you should be able to determine that you have the right part for your unit. These valves can cause many issues including SUDS codes due to inadequate water supply. I highly recommend this product and it’s a ln easy job to remove and install but I still recommend watching a short video online which are easy to find and will get you in the right direction if you aren’t sure where to start.
Triple Aries
Comentado en los Estados Unidos el 25 de junio de 2023
It's infuriating my 3 1/2 year old Whirlpool washing machine already has breaking parts but once I figured out what needed to be replaced, the repair was super simple. It entails taking off the top cover by removing a few screws and taking off this part which is straightforward. The hardest part is getting the hose off the old part. I ended up heating the hose with a hair dryer to soften it and then asked my partner, who has far more finger strength than I, to pull the hose off. Just reassemble and it all worked perfectly. It's been nearly a month since replacing and it's working fine. I swapped the hot and cold water valves bc the machine threw the error code while washing both hot and cold water loads.
Productos recomendados
Mex $450.00
Mex $ 211 .00 Mex $211.00