No hay artículos en el carro
No hay artículos en el carroMake It Work
Comentado en los Estados Unidos el 26 de febrero de 2025
attempted to screw nut onto casing... found it was too loose and did not thread on. Wrong nut sent I guess?
Long N.
Comentado en los Estados Unidos el 3 de junio de 2024
Lock nut prefer to be at the front for easy access. This unit has the lock nut in the back. Inconvenience for remove the cover and access
abbot7
Comentado en los Estados Unidos el 26 de marzo de 2022
The motor driver went out on my mini lathe. I tore apart a old rechargeable light I had lying around to utilize the female charging plug to use on a new supply that I was building for my mini lathe. I needed a female plug to power a tachometer upgrade that I was incorporating in the new panel.After all the work of tearing out a used plug and assembling it into my new panel, the used plastic plug Failed. Two hours wasted and still did not have a working tach.The short of the story, I wound up ordering and installing these metal plugs which are far superior than the plastic one I tried to salvage. All I did was make double work for myself.I should of bought these metal plugs which were easy to install and they work great! No soldiering close to the plug because they are pre-wired and fit my application without using any extra wire.I tried to save a few dollars and it bit me in the a double s.
Customer
Comentado en Canadá el 8 de diciembre de 2022
Prise d'alimentation pour des lampes de 12V.
Slidewinder
Comentado en Canadá el 8 de abril de 2022
for e-bike battery charging port
Productos recomendados