No hay artículos en el carro
No hay artículos en el carroDescripción del producto
michaelcrossland
Comentado en los Estados Unidos el 20 de marzo de 2025
So I was able to get to use this kit. ANd it's nice but my only issue I had with it was for some reason the thing would end up flipping over to Fahrenheit when it was set to Celsius. That might have been it or I might have hit something on it as I was using it. the over all size is no bigger or smaller then most cheap soldering irons on the market. The tips that it comes with did come in handy for patching up some big gaps in a print I had done. I did not have any issues getting tip changed out as long I let it cool down that is. Duoo. It very easy to use and fairly intuitive use it and get setup. Cord is a bit short but that fine that what extension cords are good for. Just makes sure that if you do get one that has a good size wire otherwise this thing will heat up the cheaper cords that you get from the dollar store.the build quality is a bit cheap but hay if your using for 3D print fix up that what you want. Overall it worth getting one them on hand if your into doing larger 3D prints that needs lots of cuts in them to print on your printer.
Robert Levandowski Jr.
Comentado en los Estados Unidos el 8 de febrero de 2025
GOOD:• Comes with an assortment of brass-alloy tips that might be useful for heat-smoothing a FDM 3D print.• Included tweezers are reasonably high quality.• Soldering iron appears to use standard Hakko T18-style tips.• Inexpensive.BAD:• Included soldering iron has absolutely no safety certifications. No UL, no ETL, not even a counterfeit CE mark. That's not what you want in an electrical appliance you hold in your hand while it heats up to metal-melting temperatures. One has to assume it's dangerous.• Generic soldering iron comes without instructions for use, such as "how to turn on."• Soldering iron heat readout is in Fahrenheit; melting points of FDM filament are typically expressed in Celsius. If it's possible to change the readout, the means of doing so isn't obvious and isn't documented.• With smoothing tip installed, heat output is nowhere close to the displayed value when tested with a calibrated Hakko FD-100 soldering-iron temperature tester: With 670°F selected on the iron, actual tip temperature was between 128° to 135°C... or about 262–275°F. This iron may struggle to reach the glass transition temperature of most filament.• Included stand doesn't fit the iron tips included, which can cause unsafe conditions.• Stand is shipped unassembled and needs careful assembly using two nuts (included), but instructions aren't provided. The stand may fail if not assembled correctly, causing a risk of fire and burn injury. It's made from thin sheet steel; the base isn't weighted. It's not adequate for the task and is unsafe.• It's a generic soldering iron with a generic brass smoothing-tip adapter, which reduces heat transfer and adds unnecessary complexity, as well as more opportunities for coming apart during use.BOTTOM LINE:Not recommended—it's unsafe, and that's before you get into the hazards of melting plastic up close.
merlin
Comentado en los Estados Unidos el 6 de febrero de 2025
Works great, great buy, love it.
Roy taylor
Comentado en los Estados Unidos el 21 de febrero de 2025
Works great for 3d printing.
josh barker
Comentado en los Estados Unidos el 22 de enero de 2025
The stand for this is completely useless. It came with the wrong sized nuts or the threads were just bad. The stand will not properly hold it casting it to fall over with the slightest bump of the table. Also changing of the tips is not easy at all.
Productos recomendados
Mex $58.79
Mex $ 31 .00 Mex $31.00
Mex $1,452.17
Mex $ 580 .00 Mex $580.00