No hay artículos en el carro
No hay artículos en el carroBill
Comentado en los Estados Unidos el 6 de marzo de 2025
These thermistors. Screw into the heat block. This virtually eliminates the possibility of it coming loose and starting a melt down. The referenced temperature vs resistance curve is accurate, as best I can measure it. The only downside to this sensor are the leads. They are very fragile.
James Ross Jr
Comentado en los Estados Unidos el 4 de febrero de 2025
Great replacement for my 3d printer. Couldn't get the old one out of my ender 3 hot end to put in my new microswiss direct drive. These worked great. Plenty of cable length
H G Chamberlain III
Comentado en los Estados Unidos el 26 de febrero de 2025
We had to replace a large mirror on a dresser, and these clips were precisely what we needed. Small and discreet, but strong enough to hold a large mirror
joseph moreira
Comentado en los Estados Unidos el 23 de marzo de 2024
They are way to small only go on half way and then just fling off
Nick
Comentado en los Estados Unidos el 1 de diciembre de 2023
The heater block for my Ender 3 v2 finally kicked the bucket after about a year and a half of dedicated service due to multiple clogs, crossthreads, and just constant use.This is a very nice replacement. I'm not sure I'm seeing a noticeable increase in hotend heating speed, but there may be a small one there. Maybe with a more powerful heating cartridge (mine is the default 40W that comes with the v2) it may make a bigger difference.Still, can't argue with the results. And I think the brass looks cooler than the steel anyway. Shame to cover it with the silicone sock, but at least I still know it's there :)
Productos recomendados