No hay artículos en el carro
No hay artículos en el carroEl Squiddo
Comentado en el Reino Unido el 14 de junio de 2023
overall very good, nice complete kit.however be very careful fitting the crush olive on the PTFE tube, its hard to get the tension of the nut correct, over-tighten and it will catch on the filament, under tighten and the tube will just pop out, also make sure to get the PTFE tube dead straight when fitting.and finally 1mm retraction.. I'll say it again 1mm retraction settings, if you keep the stock 6 odd mm you will get jams.1mm retractionsay it with me now1mm retractiononce more for the people at the back1mm retraction
Bastian H.
Comentado en Alemania el 29 de marzo de 2023
Einbau problemlos,Funktioniert super!
Mik Wadstrom
Comentado en Suecia el 10 de marzo de 2023
En sak som var mindre bra var att fläkten inte passade utan sitter nu med bara en skruv. Cr-10 Smart 3D skrivare
Thomas
Comentado en Alemania el 7 de octubre de 2023
Ich brauchte ein neues Hotend für mein Creality CR-5 Pro H.Mittels kleinen Adapter (den ich mir gedruckt habe), betreibe ich dieses Hotend nun mit einem Orbiter V 2.0 direct drive extruder und bin mega glücklich damit.
ZOUAOUI FAROUK
Comentado en Francia el 6 de diciembre de 2021
Je vois pas de différence
Productos recomendados