No hay artículos en el carro
No hay artículos en el carroMás información del producto
Mitch
Comentado en los Estados Unidos el 27 de enero de 2025
I don't normally write a review but these work great! I have a 2006 4runner with a 30mm sway bar. I had a clunk noise when going over bumps so I replaced sway bar end links and these sway bar bushings. Even though the end links did not help the noise, they were blown out so that's good. Next I installed these bushings and boom, noise is gone. They fit perfect!Be careful removing the bolts on the bracket. The nuts are inside the tube frame and lightly tacked in place. One side went from a 10min job to a 1-1/2 job. I don't know how long the bushings will last but its easy to swap so if it's once a year, no biggy.
D.R. Walker
Comentado en Canadá el 17 de enero de 2024
made a great difference to the handling
Nicholas G. Dupre
Comentado en los Estados Unidos el 28 de enero de 2023
2003 V-8 4runner Limited 4WD. If you are going to leave the factory skid plate in place to change these out then you need to determine whether you have the right length socket extension. Not all short 3/8 drive extensions are the same length and the head of the bolts that are holding up the sway bar bushing brackets line RIGHT up with the edge of the skid plate, unfortunately. It was also a little tricky to get one of the holes lined up during the reinstallation of the bracket so be sure to have a good long and thick screwdriver handy to line up the bracket to the frame bolt hole for the bolt to enter so you can start some threads.I am not sure I could feel much of a difference and worst of all I still have a clunk. My sway bar end links are good, new ball joints, whole new rack and pinion with inner tie rods. 3 year old ToyTech lift with Bilsteins that are still good and not leaking.This is still a good product and certainly worth the money and DIY time and effort. If for nothing else do this for the process of elimination if you are hunting down a clunk.
Customer
Comentado en Canadá el 10 de marzo de 2018
As advertised!Well made product...after all its made in the USA! Easy to install and it does what is should. Installed in my Lexus GX470...and no more rattle from the front end...11 trips last year scouting for/elk hunting in the northern Canadian wilderness over rocks and muddy back-roads chewed away my old sway bar rubber bushings...the new cool looking bushings from Moog made my Lexus GX470 drive like new again...and it only took me 45 min to install. They fit perfect and are made of much better material than original rubber. Thanks Moog.
Gabriel
Comentado en México el 10 de octubre de 2018
Me gusta comprar solamente refacciones de Buena calidad para evitar andarlas cambiando regularmente, moog es muy Buena calidad y atravez de amazon las consigues facilmente y te llegan rapido.
Productos recomendados
Mex $502.93
Mex $ 251 .00 Mex $251.00
Mex $580.09
Mex $ 313 .00 Mex $313.00
Mex $743.08
Mex $ 408 .00 Mex $408.00