No hay artículos en el carro
No hay artículos en el carroConfiguración de firmware Marlin: *13:100k Hisens 3950 1% hasta 300°C para hotend "Simple One" &"Hotend "All In One" #define TEMP_SENSOR_0 13 https://github.com/MarlinFirmware/Marlin/blob/1.1.x/Marlin/thermistortable_13 h
ANTONIOS KATSANIS
Comentado en Alemania el 14 de marzo de 2025
It operated normally,item was as described
Dean Hedin
Comentado en los Estados Unidos el 6 de julio de 2024
I used this to upgrade my printer to operate up to 325C. You need customize the firmware to do this.
mark liesicke
Comentado en el Reino Unido el 30 de diciembre de 2024
I Recently upgraded to a BMS Dragonfly by Phaetus and required a cartridge thermistor, as i found the adaptor they provided rather cheap and flimsy. I read in another review that the cable was too short, so i created an extension cable from a JST-XH connector pair, however it does natively fit an original ender 3. The thermistor is accurate up to around 300 degrees, which i tested with a heatgun. I Wouldn't trust it past 320 personally, as it runs under actual temp, rather than over.Overall this exceeds specification (in my specific unit) and is great for upgrading your hotend
Michele
Comentado en Italia el 4 de junio de 2023
Sensori di qualità, consigliati. Li uso con una Makerbase THR42
Malcolm Clark
Comentado en el Reino Unido el 16 de diciembre de 2023
Perfect fit for the creality spider all metal hotend, 3mm diameter and about 15mm long. Sadly the cable is not long enough to get back to the board for the Ender 3V2. Managed to extend the cable using the replaced wire, some solder and heat shrink but just FYI
Productos recomendados