No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Gloria
Comentado en México el 2 de octubre de 2023
Quedaron muy bien en mi cocina y los focos se ven muy bien. Solo la base que va pegad a la pared es muy pequeña y tuve que comprar una tapa galvanizada para poder instalarla. De los demás todo muy bien. Se ven fuertes.
R.H.
Comentado en los Estados Unidos el 14 de mayo de 2022
I bought these for a miter saw table I was building. Like communism they look good on paper but in reality they are horrible. They are such a low profile wheel that your floor has to be perfectly clean or the wheel will catch and not move until you remove the item. These wheels caught on a brad nail, 18 gauge at that. I'm going to replace these with a solid set of non adjustable casters and throw the old ones in the trash where they belong.
Rjgogo
Comentado en los Estados Unidos el 23 de noviembre de 2022
These are pretty good but know that the bolt is an M12, I drilled and tapped the existing nuts to put in these in. Just check and make sure you have the right threads. They may make other sizes. they make the table way less wobbly when engaged. Much more stable.
phranticness
Comentado en los Estados Unidos el 26 de octubre de 2022
I used eight 250kg casters to support a 1400 lb machine. They're rated for 4400 lbs all together. I'm skeptical of the rating, but with a conservative load they work as expected. The nice part is the ability to level the machine once you get it in position, great for a lathe, mill, or other machine tool. I think they are about as tough as a light duty floor jack, which can take a considerable load. Don't expect casters that can roll around an uneven floor like a 4" wheel could, they are tiny wheels. Keep your expectations in check and you'll be pleasantly surprised.
Alexander
Comentado en los Estados Unidos el 9 de mayo de 2021
I am using six of the model 60S for my lathe. My lathe weighs 1400 lbs, six of these casters should be more than enough, yet the lathe shakes, and rocks back and fourth. The thread in the center for adjusting the height seem to be bending. I won't be able to keep using them for my lathe like this.
Brian
Comentado en los Estados Unidos el 31 de mayo de 2021
I recently bought a Rikon lathe and Wen lathe stand. The lathe stand had 12mm feet, and I wanted to make if portable. These casters fit the bill perfectly. I can roll the lathe to the middle of my garage when I want to do some wood work, and roll it back when done. The wheels roll smoothly and the feet hold the lathe in place even when off balance when engaged. I would say the total weight of the lathe and stand is about 180 pounds. So these casters are way over rated, which I think is perfect.
Productos recomendados
Mex $718.89
Mex $ 345 .00 Mex $345.00
Mex $368.00
Mex $ 165 .00 Mex $165.00