Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

ANYCUBIC Mini purificador y calentador, driver de temperatura precalentable para la mayoría de impresoras 3D de resina LCD/SLA/MSLA, accesorio original para Photon overol M5s Pro

Envío gratis en pedidos superiores a Mex $600.00

Mex $1,315.70

Mex $ 631 .00 Mex $631.00

En stock

Acerca de este artículo

  • ANYCUBIC Mini purificador y calentador para impresoras de resina, driver de temperatura precalentable para la mayoría de impresoras 3D LCD/SLA/MSLA, reemplazo de accesorio original para Photon overol M5s Pro
  • Compatible devices: Ordenador portátil
  • Item weight: 1.45 pounds
  • Operating system: Linux
  • Item depth width height: 9.05 inches
  • Item dimensions: 8.07 inches


ANYCUBIC Mini purificador y calentador para impresoras de resina, driver de temperatura precalentable para la mayoría de impresoras 3D LCD/SLA/MSLA, reemplazo de accesorio original para Photon overol M5s Pro


D. Steele
Comentado en los Estados Unidos el 7 de marzo de 2025
I had issues with my Anycubic that were hard to diagnose. I purchased this and am very happy with most of my prints. I was dubious, but it was a reasonable cost and the tradeoff was better prints. This is mostly due to the heater and ensuring the temperature is uniform. The air purifier was a bonus. I haven't seen in the directions if you can change from Celsius to Fahrenheit or if that is possible, as I've been busy. I already owned the air cleaners that are outside the unit and use those, too. I wish I had started with this. The noise level is moderate. You can hear it in the next room, but it is a low noise, not obtrusive or annoying.
Jolly R. Blackburn
Comentado en los Estados Unidos el 6 de febrero de 2025
Works great but it's a very tight fit. I found I was bumping the unit everytime I took the lid off on my Mono X. I was afraid the sticky tape was gong to fail. I designed a 3D printed seat/cup for it to sit in that uses existing screws on the printer to hold it fast. so I'm very happy with it.
Michael Speciale, Jr.
Comentado en los Estados Unidos el 18 de febrero de 2025
Nice heater/purifier. Not sure why they call it a “mini,” though. I was barely able to squeeze it in my Anycubic Photon Mono 4K. I figured it’d fit without issue since Anycubic made it and they labeled it “mini,” but the lid sits about 1/4” askew now. I cut a small notch for the power cord using a Dremel tool. Keeps the resin warm. Set it to warm at least 10 minutes before you start printing to ensure the resin is at temp. Recommended product.
Jenn Peltier
Comentado en los Estados Unidos el 21 de enero de 2025
Nice product, that does its job of keeping my 3-printer resin comfy and warm. I recommend getting one for anyone who is having troubles with their resin in colder climates.
Daniel K. Murphy
Comentado en los Estados Unidos el 1 de diciembre de 2024
I had many issues with prints detaching or warping and wasting a lot of filament. I have a tent around my printer and even with that, these problems continued. I purchased this and use it for every print and those issues have been resolved. This heater works perfectly!
Productos recomendados

Mex $2,004.03

Mex $ 981 .00 Mex $981.00

4.4
Elegir